Pronto! 482/486/682/863 12-11
WiFi Status
1 Insert printable medium (labels, endless paper) which extends across the
entire printing width.
2 If the printout is to occur using thermal transfer printing, insert transfer
ribbon with the maximum width.
3 Press the menu button.
4 Select Test > WiFi status print menu.
5 Start printout with the ↵ button.
You can cancel the printout with the cancel button.
If the WLAN card is installed, the WiFi status function prints out
a list of the most important parameters of the accessible Wireless
Access Points. The printout occurs using the heat level and print
speed specified in the Setup > Print param. menu.
Note: The printout occurs without taking the label gaps into consideration.
This is why endless media are most suitable for this purpose.
Name Information
Channel Channel; frequency range of the Access Point
Name/BSS
ID
Name of the wireless LAN
MAC address of the Access Points
WiFi signal
strength
Scale of the WiFi signal strength
Data transfer rate
Encryption Type of data encryption
WiFi status
Pronto! 486 - 10/09/2007 -15:21:00
Firmware V3.11 (Aug 9 2007) - #111070553751
Channel Name/BSS ID WiFi signal strength Encryption
6 MyNet
●●●●●
WPA-PSK (TKIP)
00:11:6B:61:8D:C1 54,0 MBit/s
11 BT4233SA70
●○○○○
WEP
00:11:6B:61:AB:82 54,0 MBit/s
To Next Page
Loading...
Need help?
General
