Pronto! 482/486/682/863 4-3
Peel-off device version
The peel-off device version is capable of Peel-Off mode and thus has an
internal rewinder and a pulling system comprised of a rewind assist roller
and a locking system. Printing on labels or continuous media from rolls or
fanfolded media is possible.
Operation in Tear-Off mode and with the 'cutter' or 'external rewinder'
accessory is possible by installing the tear-off plate (see Removing and
installing the rewind guide plate, dispense plate or tear-off plate), as with the
standard device.
In Peel-Off mode, the label is peeled off the liner after printing. The label can
be removed by hand with the peel-off sensor (accessory). The liner is rolled
up via the internal rewinder.
For use in Internal Rewind mode remove the locking system (see Removing
and installing the locking system on page 6-13) and replace the dispense plate
with a rewind guide plate (see Removing and installing the rewind guide plate,
dispense plate or tear-off plate on page 6-12).
To Next Page
Loading...
Need help?
General
