13-6 Service functions
Load settings
You can load a printer configuration previously saved to a memory medium
(memory card, USB flash drive, Internal Flash File System) into the printer
with the Load settings function.
1 Insert memory medium.
2 Press the menu button.
3 Select Service > Load settings menu.
4 If the function Load settings is protected via a PIN, use the arrow buttons
to enter the code number and confirm with the ↵ button.
5 If several configuration files are found on the memory card, select the
desired file with the up and down buttons.
6 Press the ↵ button.
Loading of the configuration data starts. Do not remove the memory card
until the loading procedure is complete. OK is shown in the display when
the entire loading procedure is complete.
7 Press the ↵ button.
If an error occurs during the loading procedure, an error message appears in
the display. Restart the loading procedure in this case. If an error occurs
again, you must enter the configuration parameters via the operating panel.
Note: Access only possible with memory medium in the default card slot.
To Next Page
Loading...
Need help?
General
