17-2 Specifications
Cutter
The cutters have a durability of more than one million cuts. The blades are
self-sharpening. Depending on the type of material cut the blades could wear
earlier and have to be replaced. Used blades are not designed to be sharpened
again.
Material width up to (in/mm) 4.7 / 120
Min. cut length (in/mm) 0.08 / 2
Material thickness (g/m²) up to 500
Power supply peripheral connector of the printer
Note: The minimum cut length is depending on the media, in particular its
adhesive characteristics. Before use tests of the media are recommended. You
should test the media too, if the media is very hard or very thin.
Cutter Tray 4
Material width (in/mm) up to 4.7 / 120
Length of the cut pieces (in/mm) up to 3.9 / 100
Stack height (in/mm) up to 1.4 / 36
To Next Page
Loading...
Need help?
General
