Laser Exposure
G133 6-22 SM
3. B/W counter (SP3-510-005) + Color counter (SP3-510-006) > Output threshold for all
outputs (SP2-193-004: [default: 200 pages])
4. Color counter > Output threshold for color outputs (SP2-193-005: [default: 200 pages])
Interval: Job end:
This starts automatically at the end of a print job.
Line position adjustment is automatically done once if one of these conditions occurs:
1. Δt > Time threshold (SP2-193-009: [default: 300 minutes])
2. ΔT > Temperature threshold (SP2-193-008: [default: 5°C])
3. B/W counter (SP3-510-005) + Color counter (SP3-510-006) > Output threshold for all
outputs (SP2-193-002: [default: 500 pages])
4. Color counter > Output threshold for color outputs (SP2-193-003: [default: 200 pages])
Front door open/close:
This starts automatically when the front door is opened/closed.
Line position adjustment is automatically done once if one of these conditions occurs:
1. Δt > Time threshold (SP2-193-009: [default: 300 minutes])
2. ΔT > Temperature threshold (SP2-193-008: [default: 5°C])
In stand-by mode:
This is automatically done once if both conditions occur at the same time. However, it is
not done if the machine is in the energy saver mode.
1. Δt > Time threshold (SP2-193-009: [default: 300 minutes]) or ΔT > Temperature
threshold (SP2-193-008: [default: 5°C])
2. B/W counter (SP3-510-005) > Output threshold for B/W outputs (SP2-193-002:
[default: 500 pages]) or Color counter > Output threshold for color outputs
(SP2-193-003: [default: 200 pages])
After new PCU or Image Transfer Belt Unit detection
When the machine detects a new unit (one of the PCUs or the Image Transfer Belt Unit),
line position adjustment is automatically done twice.
If the main scan magnification changes
This is detected by the main scan synchronization detectors at each end of the scan line for
each color.
If the magnification changes by more than 1% (threshold adjustable SP2-193-010), line
position adjustment is done again.
To Next Page
Loading...
Need help?
General
