Controller Options
SM 1-55 G133
Installation
1.11.2 SD CARD APPLI MOVE
Overview
The service program “SD Card Appli Move” (SP5-873) lets you copy application programs
from one SD card to another SD card.
You cannot run application programs from Slot 3. However you can move application
programs from Slot 3 to Slot 2 with the following procedure.
Do not remove the system card from slot 1.
Make sure that the target SD card has enough space, and put it in slot 2.
1. Enter SP5873 “SD Card Appli Move”.
2. Then move the application from the SD Card in Slot 3 to the card in slot 2.
Do steps 1-2 again if you want to move another application program.
3. Exit the SP mode.
Be very careful when you do the SD Card Appli Move procedure:
The data necessary for authentication is transferred with the application program from
an SD card to another SD card. Authentication fails if you try to use the SD card after
you copy the application program from one card to another card.
Do not use the SD card if it has been used before for other purposes. Normal operation
is not guaranteed when such an SD card is used.
Remove the cover [A] ( x 2), and then keep the SD card in the place [B] after you
copy the application program from one card to another card. This is done for the
following reasons:
1. The SD card can be the only proof that the user is licensed to use the application
program.
2. You may need to check the SD card and its data to solve a problem in the future.
To Next Page
Loading...
Need help?
General
