To Next Page

To Previous Page

PCDU

G179 3-18 SM

3.5.4 CHARGE ROLLER AND CLEANING ROLLER

1. Drum ( Drum)

2. Push the charge roller holder [A] toward the front of the drum unit ( x 2) and remove

the spring [B].

3. Charge roller [C].

 Disengage the charge roller on the right side to remove it. Try to avoid

touching the charge roller.

4. Cleaning roller [D]

 Disengage the cleaning roller on the left to remove it.

5. After replacing the charge roller and cleaning roller, check the value of SP2001-001. If

it is not at the standard value (1500), set SP2001-001 to "1500".

 If this is not done, the carrier will be attracted to the drum because the charge

roller voltage will be too high.

 After re-assembly, make sure that the front spring of the movable cleaning

blade is re-attached to the ,  position. ( Drum)

3.5.5 DRUM CLEANING BLADE 2

1. Drum ( Drum)

2. Charge roller and cleaning roller ( Charge Roller and Cleaning Roller)

CÓPIA NÃO CONTROLADA

Ricoh G179 User Manual

Questions and Answers: