Drum Charge
G179 6-20 SM
Correction for Paper Width and Thickness
This correction is done for the bypass tray only.
The by-pass tray can be used for non-standard paper narrower than sizes
accepted by the paper trays. Thicker paper, OHP sheets, etc. can also be loaded
in the by-pass tray but adjustments must be performed with the SP modes listed
below in order to avoid jams and print quality problems.
SP Mode SP Name
SP2001-001 Charge Bias Width 216 - 297 mm (Default: -1500 V)
SP2914-001 C-alpha Adjust 10V/step (Default: 150 V)
SP2914-002 C-beta Adjust 10V/step (Default: 0 V)
The way that these SP modes are used is shown below.
For example, with the default settings, if the paper width fed from the by-pass tray is 200
mm, the charge roller voltage will be –1500 +0 V.
To Next Page
Loading...
Need help?
General
