Updating the Firmware
G179 5-158 SM
Program UpDate Menu P.02
Web Support
3. Push "OK" to select a module and then the update screen appears on the LCD.
Program UpDate Menu P.02
Web Support
UpDate Exit
4. Press "UpDate" to start updating. An asterisk appears in the loading screen and
asterisks replace the underscores in the progress line as the data updates.
Loading
_ _ _ _
5. Push [#Enter] to start the update of the selected module.
When the update is completed, you will see:
Update done.
Web Support
Card No.:1/1
If firmware update does not complete successfully, try to update it again. If firmware
update always fails, replace the controller board.
6. Turn the machine off.
7. If you are finished, remove the SD card from the slot and turn the machine on.
-or-
If you need to update another module, leave the SD card in place, turn the machine on
again and repeat this procedure from Step 1.
Firmware Update Error
If a firmware update error occurs, this means the update was cancelled during the update
because the module selected for update was not on the SD card.
To Next Page
Need help?
General
