110
MFX/IFX Parameters
61 EPAmpSim
0
Tremolo
L in
R in
L out
R out
Parameter Value Explanation
Type
Type of amp
OLDCASE
A standard electric piano sound of the early
70s
NEWCASE
A standard electric piano sound of the late
70s and early 80s
WURLY A standard electric piano sound of the 60s
Bass -50–+50 Amount of low-frequency boost/cut
Treble -50–+50 Amount of high-frequency boost/cut
Tremolo Switch OFF, ON Tremolo on/o
Tremolo Speed
(sync
sw)
OFF, ON
If this is ON, the rate synchronizes with the tempo
of the rhythm.
&
“TEMPO” (p. 52)
Tremolo Speed (Hz) 0.05–10.00 [Hz]
Rate of the tremolo eect
Tremolo Speed
(note)
Note
&
“Note” (p. 120)
Tremolo Depth 0–127 Depth of the tremolo eect
Tremolo Duty -10–+10
Adjusts the duty cycle of the LFO waveform
used to apply tremolo.
Speaker Type
LINE, OLD, NEW,
WURLY, TWIN
Type of speaker
If LINE is selected, the sound will not be sent
through the speaker simulation.
OD Switch OFF, ON Overdrive on/o
OD Gain 0–127 Overdrive input level
OD Drive 0–127
Degree of distortion
Also changes the volume.
Level 0–127 Output Level
62 EPAmpSim
0
Chorus
L outL in
R in
R out
Balance W
Balance W
Balance D
Balance D
Parameter Value Explanation
Type
Type of amp
OLDCASE
A standard electric piano sound of the early
70s
NEWCASE
A standard electric piano sound of the late
70s and early 80s
Bass -50–+50 Amount of low-frequency boost/cut
Treble -50–+50 Amount of high-frequency boost/cut
Chorus Switch OFF, ON Chorus on/o
Chorus Pre Delay 0.0–100 [msec]
Adjusts the delay time from the direct sound
until the chorus sound is heard.
Chorus Rate
(sync sw) OFF, ON
If this is ON, the rate synchronizes with the
tempo of the rhythm.
&
“TEMPO” (p. 52)
Chorus Rate (Hz) 0.05–10.00 [Hz]
Frequency of modulation
Chorus Rate
(note)
Note
&
“Note” (p. 120)
Chorus Depth 0–127 Depth of modulation
Parameter Value Explanation
Chorus Balance D100:0W–D0:100W
Adjusts the volume balance between the
sound that is sent through the chorus (W)
and the sound that is not sent through the
chorus (D).
Speaker Type
LINE, OLD, NEW,
WURLY, TWIN
Type of speaker
If LINE is selected, the sound will not be sent
through the speaker simulation.
OD Switch OFF, ON Overdrive on/o
OD Gain 0–127 Overdrive input level
OD Drive 0–127
Degree of distortion
Also changes the volume.
Level 0–127 Output Level
63 EPAmpSim
0
Flanger
L out
R out
Balance W
Feedback
Balance W
Balance D
Balance D
L in
R in
Parameter Value Explanation
Type
Type of amp
OLDCASE
A standard electric piano sound of the early
70s
NEWCASE
A standard electric piano sound of the late
70s and early 80s
Bass -50–+50 Amount of low-frequency boost/cut
Treble -50–+50 Amount of high-frequency boost/cut
Flanger Switch OFF, ON Flanger on/o
Flanger Pre Delay 0.0–100 [msec]
Adjusts the delay time from the direct sound
until the anger sound is heard.
Flanger Rate
(sync sw) OFF, ON
If this is ON, the rate synchronizes with the
tempo of the rhythm.
&
“TEMPO” (p. 52)
Flanger Rate (Hz) 0.05–10.00 [Hz]
Frequency of modulation
Flanger Rate
(note)
Note
&
“Note” (p. 120)
Flanger Depth 0–127 Depth of modulation
Flanger Feedback -98–+98 [%]
Adjusts the proportion of the anger sound
that is fed back into the eect. Negative (-)
settings will invert the phase.
Flanger Balance D100:0W–D0:100W
Adjusts the volume balance between the
sound that is sent through the anger (W)
and the sound that is not sent through the
anger (D).
Speaker Type
LINE, OLD, NEW,
WURLY, TWIN
Type of speaker
If LINE is selected, the sound will not be sent
through the speaker simulation.
OD Switch OFF, ON Overdrive on/o
OD Gain 0–127 Overdrive input level
OD Drive 0–127
Degree of distortion
Also changes the volume.
Level 0–127 Output Level
To Next Page
Loading...
Need help?
General
Weight and Dimensions
