88
MFX/IFX Parameters
09 Humanizer
Adds a vowel character to the sound, making it similar to a human
voice.
L in
R in
L out
R out
Pan L
Pan R
Parameter Value Explanation
Drive Sw OFF, ON Overdrive on/o
Drive 0–127
Degree of distortion
Also changes the volume.
Vowel1 a, e, i, o, u Selects the vowel.
Vowel2 a, e, i, o, u Vowel2
Rate
(sync sw) OFF, ON
If this is ON, the rate synchronizes with the
tempo of the rhythm.
&
“TEMPO” (p. 52)
Rate (Hz) 0.05–10.00 [Hz]
Frequency at which the two vowels switch
Rate
(note)
Note
&
“Note” (p. 120)
Depth 0–127 Depth of the eect
Input Sync Sw OFF, ON
LFO reset on/o
If this is ON, the LFO for switching the
vowels is reset by the input signal.
Input Sync Threshold 0–127 Volume level at which reset is applied
Manual 0–100
Point at which Vowel 1/2 switch
0–49: Vowel 1 will have a longer duration.
50: Vowel 1 and 2 will be of equal duration.
51–100: Vowel 2 will have a longer
duration.
Low Gain -15–+15 [dB] Gain of the low range
High Gain -15–+15 [dB] Gain of the high range
Pan L64–63R Stereo location of the output sound
Level 0–127 Output Level
10 Speaker Simulator
Simulates the speaker type and microphone settings used to record
the speaker sound.
L in L out
R outR in
Parameter Value Explanation
Speaker Type
Cabinet
Diameter (in
inches) and
number of the
speaker
Microphone
SMALL 1
Small open-back
enclosure
10 Dynamic
SMALL 2
Small open-back
enclosure
10 Dynamic
MIDDLE
Open back
enclosure
12 x 1 Dynamic
JC-120
Open back
enclosure
12 x 2 Dynamic
BUILT-IN 1
Open back
enclosure
12 x 2 Dynamic
BUILT-IN 2
Open back
enclosure
12 x 2 Condenser
BUILT-IN 3
Open back
enclosure
12 x 2 Condenser
BUILT-IN 4
Open back
enclosure
12 x 2 Condenser
BUILT-IN 5
Open back
enclosure
12 x 2 Condenser
BG STACK 1
Sealed enclosure 12 x 2 Condenser
BG STACK 2
Large sealed
enclosure
12 x 2 Condenser
MS STACK 1
Large sealed
enclosure
12 x 4 Condenser
MS STACK 2
Large sealed
enclosure
12 x 4 Condenser
METAL STACK
Large double
stack
12 x 4 Condenser
2-STACK
Large double
stack
12 x 4 Condenser
3-STACK
Large triple stack 12 x 4 Condenser
Mic Setting 1, 2, 3
Adjusts the location of the microphone that is
recording the sound of the speaker.
This can be adjusted in three steps, with the
microphone becoming more distant in the
order of 1, 2, and 3.
Mic Level 0–127 Volume of the microphone
Direct Level 0–127 Volume of the direct sound
Level 0–127 Output Level
To Next Page
Loading...
Need help?
General
Weight and Dimensions
