30
Step-Recording a Phrase
Drum Track: TR-REC
1.
Press the PAD MODE [NOTE] button.
The pad mode is set to Note mode.
2.
Press a pad (key) to select the pad that you want to edit.
The selected pad is lit, and now you can use the step buttons to
edit the notes of the selected pad.
3.
Press the step buttons for the steps at which you want to
input notes.
Notes are input.
If the EDIT screen is also shown, the screen shows the notes that
you input.
4.
Repeat steps 2–3.
Increasing the Measures
Here you can make settings for the notes of the clip.
1.
Hold down the [SHIFT] button and press the MEASURE [<] [>]
buttons.
The CLIP SEQ SETTING: MEASURE screen appears.
Editing the Steps
1.
Press a pad to select the pad that you want to edit.
2.
Hold down the [SHIFT] button and press a step button.
The EDIT STEP screen appears.
3.
Use the cursor buttons to switch tabs, and use the [C1]–[C4]
knobs to edit the parameters.
Tab Parameter Explanation/Controller
MOTION tab
Here you can make settings related to Motion.
&
For details, refer to “Recording Knob Movement in Steps
(MOTION)” (p. 34).
FILTER
Adjust the motion value of each knob.
OFF, 0–127
MOD
FX
Tab Parameter Explanation/Controller
NOTE (1/2) tab
VEL
Adjusts the velocity.
[C1] knob
START
Adjusts the timing at which the start note
begins.
[C2] knob
MUTE
Adjusts the probability that a mute note will
sound.
[C3] knob
SUB STEP
Species a sub step.
[C4] knob
NOTE (2/2) tab END
Species the end timing of the end note.
[C1] knob
* By holding down the [CLEAR] button and pressing the currently-selected step
button, you can delete a note.
Track Pad Mute
Here’s how to specify drum pad muting for each track.
This function is useful during a live performance when you want to add
development to your song by inserting and removing pads.
1.
While holding down the [SEL] button of a drum track, press
the pad that you want to mute.
The pad you specied is muted.
This setting applies to the track, and is maintained even if you
change clips.
2.
Once again, hold down the [SEL] button and press the pad.
Muting is cleared.
* This is also available if the pads are set to something other than Note mode.
Clip Pad Mute
Here’s how to specify drum pad muting for each clip.
By inserting or removing parts, you can create additional variations of a
drum pattern.
1.
Press the PAD MODE [NOTE] button.
The pads are in Note mode.
2.
While holding down the [MUTE] button, press the pad that
you want to mute.
The specied pad is muted.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
