34
Movements of the [FILTER], [MOD], and [FX] knobs (MOTION) can be
recorded in a clip.
Turning Motion On/O
For each clip, you can specify whether Motion is played back.
If the MOTION [ON] button is lit, the recorded movements (Motion) of
the [FILTER], [MOD], and [FX] knobs are played back.
1.
Press the MOTION [ON] button to make it light.
Motion plays back.
2.
Press the MOTION [ON] button to make it go dark.
Motion playback ends.
Recording Motion
When the MOTION [REC] button is lit, movements (Motion) of each
track’s [FILTER], [MOD], and [FX] knobs are recorded in the currently
playing step.
1.
Play back the clip.
2.
Press the MOTION [REC] button to make it light.
Motion recording starts.
3.
Operate the [FILTER], [MOD], and [FX] knobs.
The knob movements are recorded in each step of each track.
4.
Press the MOTION [REC] button to make it go dark.
Motion recording ends.
Deleting Motion
1.
In the home screen, move the cursor to select a clip.
2.
Hold down the [SHIFT] button and press the MOTION [ON]
button.
A conrmation message asks you whether you want to delete the
Motion of the currently selected clip.
3.
Use the cursor buttons to select “O K ,” and then press the
[ENTER] button.
The Motion is deleted.
If you decide to cancel, choose “CANCEL” and then press the
[ENTER] button.
Deleting the Motion of a Specic Knob
1.
While holding down the MOTION [ON] button, turn the
knob whose Motion you want to delete.
The Motion of the specied knob is deleted.
Editing Motion
In the EDIT STEP screen, you can edit the Motion for each step.
1.
While holding down the [SHIFT] button, press a step button.
The EDIT STEP screen appears.
2.
Press the cursor [<] button to select the “MOTION” tab.
Step
3.
Use the MEASURE [<] [>] buttons and the step buttons to
select the step that you want to edit.
Parameter Value Explanation
FILTER
OFF, 0–127 Adjust the motion values of each knob.
MOD
FX
4.
When you have nished editing, press the [EXIT] button to
return to the home screen.
Switching the Motion that’s edited or viewed by the step
buttons
Steps that contain Motion data are indicated by whether the
corresponding step button is lit (data exists) or unlit (no data).
For the Motion data that is indicated by illuminated step buttons, an
“@” or “A” icon appears at the left of the parameter name.
Icon identifying the Motion data indicated by illuminated step buttons
1.
Press the PAD MODE [NOTE] button.
The pads are in Note mode.
2.
While holding down the [SHIFT] button, press a step button.
The EDIT STEP screen appears.
3.
Press the cursor [<] button to select the “MOTION” tab.
4.
At the “MOTION” tab, press the cursor [ ] button.
The “@” icon changes to “A.”
5.
Use the cursor [<] [>] buttons to select the Motion that is
indicated.
Recording Knob Movement in Steps
(MOTION)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
