256 • Appendix Sam4POS Operators Manual v2.33
EFT Operation
EFT Operation Menu
Sam4POS supports credit card processing with Datacap integrated payment appliance and supports the EMV
integration protocol. (There will be no Non-EMV integration.) Credit Card (EFT) maintenance operations can be
performed at the Sam4POS terminal from the EFT Operation menu.
In the Pre-EMV environment Datacap stored some information in the Tran that allowed the registers to run some
reports, such as the local transaction report.
In the EMV environment Datacap no longer stores information in the Tran so there are no reports available.
On the Sam4POS we are storing some information on the approvals at the register. This is required to be able to
perform “By Record” transactions.
Currently, if a Local Transaction Report is run, we print the information from the approvals. However, this data
should only be used for troubleshooting and should not be relied upon as accurate.
For example, if you perform a sale for $1.00 and then perform a Void by Record Number of the same transaction,
you will have two transactions. The register is only printing the information from the approvals.
Refer to the “Datacap Operation Definitions” on page 257 for details about these options.
1. From the main PROGRAM MODE menu, select DEVICE, then choose EFT OPERATION, from the
device menu selections.
2. The EFT Operation menu is displayed; select the Datacap_Operation.
3. Refer to the appropriate Operation Definition menu below for information on each operation.
To Next Page
Need help?
General
