258 • Appendix Sam4POS Operators Manual v2.33
EFT Operation Function Key
To avoid giving employees access to the Program mode, certain EFT operations can be accessed from the REG
mode using the EFT OPERATION function key.
Note: Batch operations may be restricted to employees with assigned authority levels for these functions.
Refer to the “Datacap Operation Definitions” on page 257 for details about these options.
The EFT OPERATION function menu options shown here are with the “Use EMV Datacap” option enabled. You
can access the operations on the EFT OPERATION function menu in one of two ways:
1. While in REGISTER mode, press the EFT OPERATION function key assigned to the Real-Keyboard or
to an MLU on the display; select the desired operation from the list.
2. Enter the shortcut numeral for the operation and press the EFT OPERATION function key. This facilitates
access to a specific operation through a macro. The shortcut numerals are shown below.
[1]
Close Batch
[2]
Void Sales By Record Number
[3]
Void Return By Record Number
[4]
Gratuity Entry
[5]
Get Gift Card Balance
[6]
Get EBT Balance
[7]
EMV Voucher For EBT
[8]
Clear EMV File
[9]
Zero Auth
[10]
Pin Pad Reset
[11]
Reprint Batch
For example, if you wanted to allow an employee to be able to get a gift card balance only, you could create a
MACRO to allow the operation from the REG mode. The MACRO would then be assigned to a keyboard position
or MLU/FLU.
The MACRO sequence would simply be the numeric #5 followed by the Datacap function key:
[5]
[EFT OPERATION]
To Next Page
Loading...
Need help?
General
