114 Using Bluetooth
Connecting a Bluetooth headset to OpenScape CP700/700X
The Bluetooth headset must now be connected to the OpenScape CP700/700X.
€ Select the Bluetooth headset in the list.
Confirm with the Softkey to connect. You will receive a corresponding confirma-
tion. The connection is immediately established and the headset is ready for op-
eration.
Testing a Bluetooth headset
. Press the key shown. You should now hear the on-hook signal in the headset.
The input field is opened.
j Enter the phone number.
Z Confirm that the phone number is complete or wait until the autodial delay ex-
pires (see ïƒ page 88).
or
The required contact is shown in the list. Confirm with the Softkey. The connec-
tion is set up.
Adjust the call volume on the headset if appropriate.
?
Headset
-Ž
¦_
Once your Bluetooth headset is connected to the telephone device, you
can see the headset’s battery level in the status bar.
©
Dial a number...
A
©
082631565
O
Peter Maier O
_
To Next Page
Loading...
Need help?
General