Unify OpenScape 4000 User Manual

96 Making calls
Press the Softkey. You are connected with the second party. The first call re-
mains on hold.
Connecting parties
You can connect the first party with the party you consulted, clearing down your
connection to both parties in the process.
Prerequisite: You are conducting a consultation call  page 91 and you are in
the call menu of an active call.
Press the Softkey. The other two parties are now connected to one another. You
can now hang up.
or
Connecting by hanging up
Prerequisite: Call joining must also be allowed  page 210.
] or É Replace the handset or, if you are in speakerphone mode, press the loudspeak-
er key. The other two parties are now connected to one another.
Placing a call on hold
You can use this function to place an ongoing call on hold, for instance to prevent
the other party overhearing a conversation with a colleague in the same room.
The held party hears music on hold.
Ä Press the fixed Hold key.
or
Press the Softkey. The call is now on hold.
or
Press the Function key. The key illuminates. (The "Hold" key has to be config-
ured on the OpenScape Key Module 600 or in the Favourites menu
 page 136).
It is documented in the main menu and in the conversations menu that a call is
on hold. The call display lights up orange at the same time.
Retrieving a held call:
Press the Softkey. You resume the call.
or
Press the illuminated "Hold" Function key. (The "Hold" key has to be pro-
grammed  page 136.)
Disconnecting a held call:
Reconnect
Ù
_
Complete transfer
D
_
Hold
I
_
â Hold I
_
If you do not retrieve the held call after a defined time interval, a reminder
beep sounds three times and only the two functions "Retrieve held call"
and "End" are shown on the display. The call display flashes orange and
the phone rings. The relevant settings can be fond on  page 208 and
 page 208.
Reconnect
Ù
_
â Hold C
¤

Unify OpenScape 4000 Specifications

General

Brand	Unify
Model	OpenScape 4000
Category	Telephone
Language	English