Xerox 2510 User Manual

CQ 7 Developer Bead Carryover
Probable Cause
Corrective Action
No copy defect sample is needed.
Charge voltage on photoreceptor drum
is
1.
too high.
Developer material has made more than
2.
30K feet (9K metres) of copies.
The dry ink concentration in the developer
3.
is not high enough. This will cause the
developer material to fail.
Developer material dumping onto Media
Transport.
Perform the Electrostatic Series (2510
ADJ 9.2; 251 5 ADJ 9.3.)
Replace the developer material (REP
9.8) and perform the Electrostatic Series
(251 0 ADJ 9.2; 251 5 ADJ 9.3.)
Replace the developer material (REP
9.8) and perform the Electrostatic Series
(2510 ADJ 9.2; 251 5 ADJ 9.3.)
Ensure that photoreceptor drum is fully
seated on the drum shaft and
is not
rotating out-of-round.
Xerographic Module
is moving away
from the photoreceptor drum. Check
that there
is sufficient oil on the fuser.
2510 install Tag 24. 2515 ensure that
the bracket that holds the right side of
xerographic module
is pushed against
the drum shaft.
Worn drive gears on the right side of
the Developer Housing
(2510 ONLY) The Magnetic Roll hub on
the right side
is damaged. Rebuild the
Developer Housing
The magnetic Roll surface
is worn
smooth. 251
0 rebuild the Developer
Housing, 2515 replace the Developer
Housing,
The Developer to Roll Spacing (DRS)
is
out of specification. Contact DTS to
check using the DRS Tool.
Trimmer bar gap
is out of specification.
Rcplaco tho Developer Housing.
CQ 7 Developer Bead Carryover

Xerox 2510 Specifications

General

Brand	Xerox
Model	2510
Category	Copier
Language	English