Xerox 2510 User Manual

ADJ 3.3 Timeout Interval to
Power Saver Mode
(251 5)
Purpose
The purpose is to set the amount of time it takes
the copier to return to the standby mode from
the run mode.
Introduction
The timeout interval should be set to the
requirements of the customer. The time
is
preset by manufacturing for 1 minute. The time
interval can be set from
45 seconds to 3
minutes.
Adjust
1. Enter the diagnostic mode.
2. Select test 1. Press Start.
3. Use the Copy Contrast LlghterlDarker
buttons to increaseldecrease the value
displayed on the control panel.
NOTE: Increasing the value displayed will
increase the run time interval after the
last copy was made. One number will
increase or decrease the interval by
15
seconds,
4. Press the Start button to enter and store the
new setting.
5. Exit the diagnostic mode.
AD1 3.4 Foreign Accessory
Enablement
Purpose
The purpose is to select or deselect the foreign
interface feature and determine the interaction
of the foreign interface output pulse.
Adjust
1. Enter the diagnostic mode.
2. Enter code 1 (2510 WlTag 26) or enter code
2 (25 15). Press Start.
3. Enter the cleisred vnlue.
1 Function 1 value
The foreign interface
is enabled and
an output pulse
is generated at the
completion of each copy.
5.
Exit the diagnostic mode.
The foreign interfce
is not enabled.
The foreign interface
is enabled and
an output pulse
is generated each
time the copy count meter registers
on increment.
7/92
25101251 5 4-57 ADJ 3.3, ADJ 3.3,
2
3

Xerox 2510 Specifications

General

Brand	Xerox
Model	2510
Category	Copier
Language	English