Xerox 2510 User Manual

U - Copy Count Meter RAP
Initial Actions
The status code U will be displayed if there is
an open circuit in the wiring to the copy
count meter.
Ensure that the Country Configuration
(ADJ
3.3) is adjusted correctly before performing
this
RAP.
Procedure
Set the meter to measure + 24 VDC.
Connect
( +) to P12-2 of the Control PWB; (-)
to the GND test point on the HVPS (TP4).
There
is + 19 to + 35 VDC present.
Y N
Switch off and unplug the copier. Go to
FLAG 1 and check for an open circuit
between the copy count 'meter and the
Control PWB.
Enter the diagnostic mode.
Enter the code
[PI for the copy count meter.
Note: the copy count meter advances
each timer the diagnostic code (P)
is entered.
There is less than + 2 VDC at P12-2.
Y N
I Replace the Control PWB.
Replace the copy count meter.
If the problem
still exists, replace the Control
PWB.
/ CONTROL PWB
I f;ImuNT
METER
-
U - Copy Count Meter ~AP

Xerox 2510 Specifications

General

Brand	Xerox
Model	2510
Category	Copier
Language	English