I
REP
9.1
1
TONER SENSOR
ASSEMBLY
2.
REMOVE THE DEVELOPER MODULE (REP9.6).
3.
REMOVE THE DEVELOPER MATERIAL (REP
9.9).
PARTS LIST
ON
PL
9.5
REMOVAL
4.
IF
PRESENT, REMOVE THE CLEAR PLASTIC
COVER,
5.
(FIGURE
1):
REMOVE THE TONER SENSOR
1.
WARNING: DISCONNECT THE POWER ASSEMBLY.
CORD.
The developer material must be
removed before removing the toner
sensor assembly.
B
REMOVE SCREWS
(2)
A'
DISCONNECT
Figuro
1.
Romove tho Tonor Sonsor Assombly
IkERl
REPLACEMENT
NOTE: Do not force the Toner Sensor into
the hole.
If
the sensor does not go
in
easily,
order
a
new sensor.
1.
INSTALL THE TONER SENSOR ASSEMBLY.
2.
INSTALL THE CLEAR PLASTIC COVER.
3.
INSTALL THE PICK
OFF
BAFFLE WITI-1 THE
CORRECT SIDE
UP.
4.
INSTALL THE DEVELOPER MODULE(REP
9.6).
5.
INSTALL THE DEVELOPER BY POURING
EVENLY END-TO-END WHILE TURNING
THE MAIN MOTOR, BY HAND, IN THE
DIRECTION INDICATED BY THE ARROW
ON THE FAN.
6.
INSTALL THE TONER CARTRIDGE.
7.
PERFORM THE ELECTROSTATIC
SERIES
(ADJ
9.3).
8/96
251
5
4-30A
REP
%l'I
To Next Page
Loading...
Need help?
General