STATUS
CODE
A
b
1
Flashing
b
C
J
Low Toner
Light not Lit
1
Low Toner
Light Lit
U
Constant
P
Constant
L9
or
L8
CAUSE
CLEARANCE PROCEDURE
GO TO RAP
IN
SECTION
2
A
document was inserted before the
Remove document, press
Start
and wait for
Ready
to
A
-
Document Sensor RAP
copy paper
was
registered. come on and reinsert copy paper and document.
Control PWB Failure
The transport latching cover
is
open or
the
upper
roor
cover
is
off.
Paper Path
Jam.
Fuser Failure
Foreign accessory prevents printing or
has a malfunction
Excessive toner concentration
Insufficient toner concentration
Copy Count Meter
is
disconnected.
Copier
is
in
its
warm up cycle.
Copier
is
in the power saver mode.
Copier does not warm up.
Switch off the copier, then switch on the copier.
Record the
NVM
values.
Replace the control pwb.
1
(2515
only) Enter the
NVM
values recorded previously.
Reset
NVM.
Select the lower right hand segment.
Close the transport latching cover. Check that the
upper
rear
cover
Is
In
place.
Clear the paper jam. Open, then close the transport
latching cover
Switch off the copier, then switch on the copier.
Insert required coin or cord,
Replace dry
ink
cartridge, Run copier for three time-
out cycles.
Reconnect counter,
Wait for Fuser to warm up. Display should
be
counting down from
L9
to
LO.
Press the
Start
button.
Switch off the copier, then switch on the copier.
C
-
Cover Interlock Open RAP
E
-
Paper Path Jam RAP
F
-
Fuser RAP
W
-
foreign accessory Hap
3.2
or
3.3
J
-
High Torler Concentration
RAP
1
J
-
Low Toner Concentration
RAP
2
U
-
Copy Count Meter RAP
F
-
Fuser RAP
Status
Code
Entry
Chart
To Next Page
Loading...
Need help?
General