Xerox 2510 User Manual

REP 6.1 Exposure Lamp
Parts List on PL 6.1
Replacement
NOTE: Ensure that the heatsink is in place in
the center of the exposure lamp and
it
is not touching the rear document
drive rolls shaft.
I
NOTE: Ensure that the lamp part number is at
the right side of the machine and the clear
slot
is facing the illumination Sensor.
WARNING
(251 5 W/ Tags 2,7, or 89): There will be a
time delay between the time the code
[A] is
entered and the time the motor starts to turn.
The motor will not start until the fuser
is at
the correct temperature.
Enter the diagnostic mode.
(2510,2515 W/O Tag 2,7, or 89):
Enter the code [L] and press Start.
Enter the code [g] and press Start.
Enter the code [J] and press Start.
Wait 2 minutes..
Enter the code (A) and press Start.
(2510,2515 W Tag 2.7, or 89):
Enter the code (A) and press Start.
Enter the code
IF] and press Start.
Allow the copier to run for
4 minutes to
prepare the new lamp for use.
Press Stop.
Perform the electrostatic series
(2510ADJ
9.2; 2515 ADJ 9.3).
REP6.2 ~=ns
Parts List on PL 5.1
Removal
1. WARNING: Disconnect power cord.
2. Remove the document handler.
3. Remove the platen.
4. Remove the exposure lamp.
5. (Figure 1): Remove the lens.
VlEW FROM THE REAR
Figure 1. Removing the Lens
Replacement
1. (Figure 2): Observe correct lens position.
NOTE: Step 1A: There are six slots in the frame
into which the lens pins can be installed.
The slots
in the lower position are for
the
251 Ol251S. The slots in the upper
position are for the
2520. Locating the
lens pins in the upper slots will cause an
out of focus condition in the
2510 and
25 15.
I
INSTALL PINS INTO THE
LOWER SLOTS
(3 PLACES)
I
VlEW FROM
THE REAR
Figure 2. The Correct Lens Position
LENS
REP 6.1, REP 6.2

Xerox 2510 Specifications

General

Brand	Xerox
Model	2510
Category	Copier
Language	English