Xerox 2510 User Manual

<
ADJ 3.1 Tirneout Interval To
RestMode
Purpose
I
The purpose is to set the amount of time in
which the copier returns to the rest mode
from the power saver mode.
Introduction
The timeout interval should be set to the
customer's requirements. The time
is preset
by manufacturing for one hour and fifteen
minutes. The time interval can be set from
15 minutes to 2 hours and 15 minutes.
Procedure
1. Enter the diagnostics mode.
2. Use the Copy Controst UPIDOWN(2510)
or the Copy Contrast Ligh teriDarker
(2515) buttons to select test 8. Press the
Start button.
NOTE:
Increasing the value displayed will
increase the timeout interval. One number
will increase
or decrease the interval by 15
minutes.
3. Use the copy contrast UPtDOWN(2510) or
ADJ 3.2 Country Configuration
the Copy Contrast Ugh terlDarker (25 1 5)
buttons to increase/decrease the value
displayed on the control panel.
Purpose
4. Press the Start button to enter and store the
The purpose of this procedure is to set up the
new setting.
correct country configuration for the copier.
5. Exit the diagnostic mode.
Procedure
1. Enter diagnostic mode.
2. UsetheCopyContrastUP/DOWN(2510)or
the Copy Contrast LlghterlDarker (251 5)
buttons to select test 9. Press the Start
button.
3. Using the copy contrast buttons, select the
appropriate configuration code and press
Start to store the new configuration value.
Code Configuration
4. Exit the diagnostic mode.
ADJ 3.1, ADJ 3.2,

Xerox 2510 Specifications

General

Brand	Xerox
Model	2510
Category	Copier
Language	English