Xerox 2510 User Manual

A - Document Sensor RAP
Status code A will be displayed if a document
is inserted before the copy paper is
registered. This could occur if the actuator
that blocks the documont sonsor Is blnding.
Q
The circuit diagram is on the next page.
Procedure
Enter the code [Top Right Segment] to check
the document sensor.
NOTE: The Film Led is lit on the Control
Panel when the sensor is blacked,
Actuate the Document Sensor
(QI).
The
appropriate lamp goes on then off when the
sensor is actuated.
Y N
Initial Actions
Check the actuator of the document
sensor for damage or binding.
e Check the document path for
obstructions and the Transport
Platen and the platen for damage
and for correct installation.
Clam the sensor.
A B
Go to FLAG 1 and check the wiring for nn
open circuit or a short circuit.
If there
is no open or short circuit,
replace
the Document Sensor (QI).
If the problem persists, replace the
Control
PWB.
The problem could be an intermittent
Document Actuator or Sensor. Refer back to
the Initial Actions section
of this RAP. If the
problem persists, replace the Document
Sensor.
6/96
A - Document Sensor RAP
2-2

Xerox 2510 Specifications

General

Brand	Xerox
Model	2510
Category	Copier
Language	English