Xerox 2510 User Manual

CQ 22 Unfused Copy
Probable Cause
1. The fusing temperature is too low.
2. Damp media.
3. Incorrect fabric guide tension.
There
is no COPY defect sample
4. Fuser pressure plate not seated
needed. correctly.
Definition
Unfused copy is a copy where the
image can be easily wiped off the
media.
Corrective Action
la. Check/adjust the Fuser Temperature (ADJ 10. I),
1 b.Air manifold
is damaged causing air to flow on the
fuser roll reducing the temperature. Replace the Air
I
Manifold (PL 9.3)
Ic. Damaged filter housing can cause air to blow on the
fuser roll, replace the Filter Housing
(PL 9.3).
Id. (2510) Install Tag 14 to improve edge fusing.
2a. Cut sheet media
Make a copy using a sheet of media from the middle of
the stack of media in the Cut Sheet Feeder or the media
storage on the stand.
If the problem
is corrected, check that the media is
being stored correctly.
2b. Roll media
Remove and discard the first
3 to 6 feet (1 to 2 metres)
of media from the roll.
Make a copy on the new media.
If the problem
is corrected, ensure that the roll media is
being stored correctly.
3. Check that the fabric guide tensioning assembly (2510
PL 8.2, 2515 PL 8.4) is not binding and the weight is
centered in the fabric guide.
4. Ensure that the fuser pressure plate is seated correctly.
(Continued)
CQ 22 Unf used Copy

Xerox 2510 Specifications

General

Brand	Xerox
Model	2510
Category	Copier
Language	English