Xerox 2510 User Manual

CQ 20 Spots
Probable Cause
Corrective Action
(Continued)
No copy sample defect
is needed.
6. Low dry ink concentration or the
developer material
is contaminated.
(Continued)
(2515 WI Tog 2,7, or 89):
Enter the codes [L] and [A] to switch on the
main drive motor and
[Y] to check the dry ink
concentration.
(2515 WI Tag 2, or 89): If the value is less than
3 then go to the J Dry ink Concentration Fault
RAP in section 2.
(2515 WI Tag 7): If the value is less than 1 then
go to the
J Dry ink Concentration Fault RAP in
section
2.
7. Damaged auger to drum seal. 7.
8. Excessive dry ink contamination is on the 8.
return baffle near the transferldetack
corotron.
9. (2510 ONLY): Developer module seal 9.
leaking.
CAUTION
Only the 2510 developer module can be
repaired
using the developer module repair
kit. The
2515 developer module is the same as
the
2520 and cannot be repaired. The
manufacturing tolerances are much tighter
and cannot be set with out the correct tools.
Replace the auger to drum seal (PL
9.1).
Clean the contamination and then check
that the developer housing
is seated
correctly. Check for an obstruction
between the magnetic roll and the
developer housing. Check the developer
housing for damage. Reference
Troubleshooting TonerlDeveloper
Dumping, Section
6
(2510 ONLY): Replace the developer
module seal, Developer Module Repair
Kit
(PL 9.4).
10. Contaminated dry ink
10, Rcplace tho dry ink cartridge oncl also ,the
developer material (REP 9.9) and perform
the Electrostatic Series
(2510 ADJ 9.2; 251 5
ADJ 9.3).
Definition
These defects are 0.2 inches (5mm) or smaller
in diameter. These could appear at intervals
that are in
the process direction.
8/96
CQ 20 Spots 3-78 251012515

Xerox 2510 Specifications

General

Brand	Xerox
Model	2510
Category	Copier
Language	English