Xerox 2510 User Manual

Replacement
CAUTION
3. (Figure 3): Reinstall the right side of the oil
STEP
2 B: To avoid damaae to the
dispense assembly.
1. Check the stripper fingers for toner build-
stripper fingers
or the fusecheat roll,
up or damage and clean or replace as
ensure that the oil dispense assembly
is
CAUTl ON
required.
positioned up against the bracket as
STEP3 A:To avoid damage to the stripper
shown
in Figure 2, Keep the oil dispense
fingers or the fuser heat roll, keep the oil
assembly as dose to the fuser roll without
positioned up against
2.
(Figure 2): Reinstall the left side of the oil
touching the roll while instaling the
the bracket as h3~n in Figure2. Keep
dispense assembly. assembly.
the oil dispense assembly as close to the
fuser roll without touching the roll while
installing the assembly.
INS 1Al I. 1111: 011.
DISPENSI: ASSFMfl1.Y
WHILE DOING THE STEP B
ITION THE OIL
AGAINST THE BRACKET
Figure 2. Reinstalling the Oil Dispense Assembly
C
Wmag 1 1 : ENSURE
9
THAT THE OIL DISPENSE
IIIE IJIIACKf I
INSTALL THE OIL
ASSEMBLY WHILE
DOING THE STEP B
r. 1
Figure 3. Reinstalling the Oil Dispense Assembly
(Continued)
REP 10.5

Xerox 2510 Specifications

General

Brand	Xerox
Model	2510
Category	Copier
Language	English