Xerox D136 System Administration Guide

Common access card (CAC)
authentication
The common access card (CAC) authentication is part of a Department of Defense
initiative to increase the security of its facilities and critical information through the use
of smart identification cards. Eventually all department employees will use CAC cards
to gain access to computers, networks, and buildings. In many cases, the department is
requesting that same level of authentication at the printer level as well. When enabled
on the printer, Department of Defense employees need to use their CAC card to access
the machine to scan or copy documents, providing greater security and management
of their machines.
Xerox CAC Enablement software supports a number of card readers and allows users to
authenticate at the machine. The card is connected to a USB port on the printer.
Refer to the Xerox Smart Card Installation Guide for a comprehensive explanation of
how to install and configure the Smart Card solution.
Note
If the device is configured to use Network Accounting, it will need to be disabled in order
to use CAC. For details, see Network Accounting (Job Based Accounting).
Supported card types
The CAC solution is compatible with most common CAC card types listed below. Other
card types may function with the CAC/PIV ID system but they have not been validated.
• Axalto Pegasus 64K/V2
• Axalto Cyberflex 32K/V1
• Axalto Cyberflex 64K/V2
• Gemplus GemXpresso 64K/V2
• Oberthur 72K/V2
• Oberthur CosmopoIIC 32K/V1
• Oberthur D1 72K / V2 (contact-less and PIV)
• Gemalto 72K PIV ENDPOINT
• Gemalto 128K PIV ENDPOINT
• Gemalto 144K PIV ENDPOINT
Supported card readers
The following card readers are compatible with the CAC ID system.
• Gemplus PC USB SL Reader
Xerox
®
D95/D110/D125/D136 Copier/Printer12-10
System Administration Guide
Accounting and Authentication / Security Settings

Xerox D136 Specifications

General

Brand	Xerox
Model	D136
Category	Copier
Language	English