7. Type the server name, port name and domain name of any additional Kerberos
servers if desired.
8. Click Apply to accept the changes or Undo to retain the previous settings.
Configuring Authentication Server Settings for SMB
1. In CentreWare IS, click Properties > Security > Remote Authentication Servers >
SMB Server.
2. Next to SMB Server Setup, select By Domain Name or By Server Name /IP Address.
3. Type the Domain Name and Server Name/IP Address for each of your servers.
4. Click Apply to accept the changes or Undo to retain the previous settings.
Configuring Authentication Server Settings for LDAP
1. In CentreWare IS, click Properties > Connectivity > Protocols > LDAP > LDAP
Authentication.
2. Next to Authentication Method select Direct Authentication, or Authentication
of User Attributes. Direct Authentication uses the user name and password entered
by the user for authentication with the LDAP server. Authentication of User Attributes
allows you to specify what is entered by the user (Attribute of Typed User Name)
and what is used by the printer (Attribute of the Login User Name) to authenticate
the user.
3. Type the Attribute of Typed User Name.
4. Type the Attribute of Login User Name.
5. Select Enabled next to Use Added Text String, and type the text string if you want
to add text to the user input prior to authentication.
Authentication Using a Card Reader
System
Setting Up Authentication for Xerox Secure Access
Before you begin:
• Enable Secure HTTP (SSL)
• Install the Xerox Secure Access authentication server and configure with user accounts.
Refer to the authentication server documentation for help.
Note
Accounts created on the Xerox Secure Access authentication server must match
accounts stored in the printer’s local database or in another network authentication
server.
• Connect and configure your card reader.
Xerox
®
D95/D110/D125/D136 Copier/Printer5-6
System Administration Guide
Using the Scan Service
To Next Page
Loading...
Need help?
General