b. If needed, make changes to the Paper Curl and Alignment Adjustment options.
Note: For detailed information on the Paper Curl and Alignment Adjustment options, refer to the Xerox
®
PrimeLink
®
B9100/B9110/B9125/B9136 Copier/Printer System Administrator Guide.
c. Touch SSaavvee until you are returned to the Paper Tray settings screen.
9. To close the screen, touch CCoonnffiirrmm.
Loading Hole-Punched Paper
1. Select the appropriate paper stock for your print job.
2. Pull out the tray slowly until it stops.
3. Open the ream of paper with the seam side facing up.
4. Before you load the sheets of paper into the tray, fan the sheets.
5. Load and align the paper against the right side of the tray, in the SEF (short-edge feed) direction, or in the LEF
(long-edge feed) direction, as shown.
6. To adjust the paper guides, press in the guide release, then carefully move the edge guide until it lightly
touches the edges of the paper in the tray.
Do not load paper above the MAX fill line on the rear edge guide.
7. If necessary, set the skew adjustment levers to the required position for your print job.
8. Gently push in the tray until it stops.
If enabled by your System Administrator, the Paper Tray settings screen appears on the control panel touch
screen.
9. If you made changes to the paper tray, touch CChhaannggee SSeettttiinnggss. If you did not make changes to the paper
tray, do the following:
a. Select options for the PPaappeerr TTyyppee//PPaappeerr WWeeiigghhtt, PPaappeerr SSiizzee, and PPaappeerr CCoolloorr features.
b. If needed, make changes to the Paper Curl and Alignment Adjustment options.
Note: For detailed information on the Paper Curl and Alignment Adjustment options, refer to the Xerox
®
PrimeLink
®
B9100/B9110/B9125/B9136 Copier/Printer System Administrator Guide.
c. Touch SSaavvee until you are returned to the Paper Tray settings screen.
10. To close the screen, touch CCoonnffiirrmm.
Xerox
®
PrimeLink
®
B9100/B9110/B9125/B9136 Copier/Printer User Guide 319
Oversized High Capacity Feeder