EMPTYING THE HOLE PUNCH WASTE CONTAINER
When the hole punch waste container is full, a message appears on the printer control panel. When the message
appears, empty the waste container of all paper scraps.
Note: Basic Punch is an optional feature. The waste container is present only if the Basic Punch option is
part of your printer configuration.
Important:
• Before performing this procedure, ensure that the printer is not printing.
• Ensure that the printer remains powered on when replacing the staple waste container. If powered off,
the printer does not recognize the replacement of the waste container, and the message remains
displayed.
• After you replace the waste container, close the finisher front cover. Ensure that the printer can print a
test page.
1. Open the finisher front cover.
2. Pull out RR44, then remove it from the printer.
432 Xerox
®
PrimeLink
®
B9100/B9110/B9125/B9136 Copier/Printer User Guide
Production Ready Finishers
To Next Page
Loading...
Need help?
General