Yamaha YZF-R7 User Manual

7 - 17
CHAS
FRONT AND REAR BRAKES
EB702100
ACHTUNG:
CAUTION:
Disc brake components rarely require
disassembly.
Therefore, always follow these preven-
tive measures:
• Never disassemble brake components
unless absolutely necessary.
• If any connection on the hydraulic
brake system is disconnected, the
entire brake system must be disas-
sembled, drained, cleaned, properly
filled, and bled after reassembly.
• Never use solvents on internal brake
components.
• Use only clean or new brake fluid for
cleaning brake components.
• Brake fluid may damage painted sur-
faces and plastic parts. Therefore,
always clean up any spilt brake fluid
immediately.
• Avoid brake fluid coming into contact
with the eyes as it can cause serious
injury.
First aid for brake fluid entering the
eyes:
• Flush with water for 15 minutes and
get immediate medical attention.
EB702112
REPLACING THE FRONT BRAKE PADS
The following procedure applies to both
brake calipers.
NOTE:
When replacing the brake pads, it is not
necessary to disconnect the brake hose
or disassemble the brake caliper.
1. Remove:
• brake hose holder 1
• brake caliper 2
1

1

2

2


Yamaha YZF-R7 Specifications

General

Bore x Stroke	80.0mm x 68.6mm
Compression Ratio	11.5:1
Fuel Delivery	Fuel injection
Final Drive	Chain
Front Brakes	Dual 298mm hydraulic disc; ABS
Rear Brakes	245mm hydraulic disc; ABS
Front Tire	120/70ZR17
Rear Tire	180/55ZR17
Wheelbase	54.9 in
Seat Height	32.9 in
Fuel Capacity	3.4 gal
Wet Weight	414 lb
Ground Clearance	5.3 in
Engine Type	Liquid-cooled, 4-stroke, DOHC, 4-valves
Transmission	6-speed
Front Suspension	41mm KYB inverted fork, adjustable preload, rebound and compression damping; 5.1-in travel
Rear Suspension	Single shock, adjustable preload and rebound damping; 5.1-in travel