Yealink VC800 Administrator's Guide

Administrator’s Guide for Yealink VC800 Video Conferencing System
8
LED Status
Description
Off
The CPW90 is in the idle mode.
User Interfaces
Three are two ways to customize the configurations of your system:
 Web User Interface
 Remote Control
The following describes how to configure the VC800 video conferencing system via the two
methods above.
Detailed operation steps will be introduced in the feature section.
Web User Interface
You can customize your system via web user interface. To access the web user interface, you
need to know the user name and the administrator’s password. The default user name is “admin”
(case-sensitive), and the default password is “0000”. You can also access the web user interface
with user credential, which is disabled by default. For more information on how to enable the
user credential, refer to User Mode on page 227.
The system uses the HTTPS protocol to access the web user interface by default. For more
information on the access protocol for web user interface access, refer to Web Server Type on
page 229.
Log into the web user interface of the system:
1. Enter the IP address (e.g.,192.168.0.10) in the address bar of a web browser on your
computer, and then press the Enter key.
2. Enter the administrator user name and password.
3. Click Login.
After you log into the web user interface successfully, you can click Logout on the top
right corner of the web interface to log out.
Administrator has full permission to access every menu in the web user interface. User can log
into the web user interface with user credentials.

Yealink VC800 Specifications

General

Brand	Yealink
Model	VC800
Category	Conference System
Language	English