Yealink VC800 Administrator's Guide

Getting Started
19
Wake the system via the remote control:
1. Press any button on the remote control.
The indicator LED on the VC800 codec illuminates solid green.
Wake the system via the CP960 conference phone:
1. Tap the touch screen or any key.
The indicator LED on the VC800 codec illuminates solid green.
Powering the System Off
To power off the system via the remote control:
1. Press .
2. Press or to scroll to Shut down and then press .
The system shuts down immediately. The indicator LED on the VC800 codec is off.
To power on the system again via the remote control:
1. Press .
The indicator LED on the VC800 codec illuminates solid green.
System Initialization
Once you have power on the system, it will begin its initialization process.
During the initialization process, the following events take place:
Loading the ROM file
The ROM file sits in the flash memory of the system. Systems come from the factory with a ROM
file preloaded. During initialization, systems run a bootstrap loader that loads and executes the
ROM file.
Configuring the VLAN
If the system is connected to a switch, the switch will notify the system about the VLAN
information defined on the switch.
Querying the DHCP (Dynamic Host Configuration Protocol) Server
The system is capable of querying a DHCP server. DHCP is enabled on the system by default.
The following network settings can be obtained from the DHCP server during initialization:
 IP Address
 Subnet Mask
 Gateway
 Primary DNS (Domain Name Server)

Yealink VC800 Specifications

General

Brand	Yealink
Model	VC800
Category	Conference System
Language	English