Yealink VC800 Administrator's Guide

Administrator’s Guide for Yealink VC800 Video Conferencing System
18
3. Replace the battery cover.
Remote Control Battery Safety Information
 Never make wrong polarity connection when charging and discharging battery packs.
 Avoid crushing, puncturing, or putting a high degree of pressure on any battery, as this can
cause an internal short-circuit, resulting in overheating.
 Remove the batteries if they are not in use for long period of time. Battery leakage and
corrosion can damage the remote control, dispose batteries safely.
 Do not dispose used batteries in domestic waste. Dispose batteries at special collection
points or return to stores if applies.
 Do not dispose batteries in a fire.
Powering the System On
To power on the system:
1. Locate the DC48V port on the VC800 codec, and connect it to the electrical power outlet
with the supplied power adapter.
The VC800 video conferencing system starts up automatically, and the indicator LED on
the VC800 codec then illuminates solid green.
Put the System to Sleep
After a certain amount of time with no activity, the VC800 video conferencing system goes into
sleep mode automatically.
Put the system to sleep via the remote control:
1. Press .
2. Press or to scroll to Sleep and then press .
The system goes to sleep immediately. The indicator LED on the VC800 codec illuminates
solid red.

Yealink VC800 Specifications

General

Brand	Yealink
Model	VC800
Category	Conference System
Language	English