ELECTRICAL SYSTEM
8 - 24
ATLANTIC 125 - 200
8.11. BULB REPLACEMENT
8.11.1. BULB REPLACEMENT
Read
1.2.1., 1.7.1. carefully.
WARNING
Before proceeding to change a bulb, rotate the
ignition switch to “
”.Wear clean gloves or
use a clean, dry cloth to handle bulbs. Do not
put your fingerprints on a bulb, as this may
cause overheating leading to failure. If you
touch a bulb with your fingers, remove any
fingerprints with alcohol to avoid early failure.
DO NOT PULL ON THE WIRING.
• Place the vehicle on the stand.
NOTE Check the fuses before changing a bulb,
8.12.1.
PARKING LIGHT BULB
To replace:
• Remove the front cover,
7.1.10.
WARNING
Proceed carefully.
Do not damage the tabs and/or their recesses.
• Rotate and extract the bulb holder working from the
rear end of the bulb holder.
• Extract the bulb.
NOTE Make sure the locating pegs locate properly into the
holder when fitting the bulb.
• Fit a new bulb of equal rating.
HIGH AND LOW BEAM BULBS
To replace:
Open the glove compartment (1) and unhook the side guides
pressing moderately down.
To Next Page
Loading...
Need help?
General
