To Next Page

To Previous Page

Handling rolls

Selecting the Roll as the Paper Source

Y ou can switch the paper source between the roll and the sheet by pressing the Feeder Selection button.

Each time you press this button, the paper source switches between the roll (indicated by the Roll Media

lamp ) and the sheet (indicated by the Cut Sheet lamp ).

Press the Feeder Selection button to activate the Roll Media lamp (a).

Note

• Y ou cannot switch the paper source in the following situations:

• If the Message lamp is ashing

Check the message on the Display Screen and take action as necessary . ( → P .758)

• If the Data lamp is ashing

Select the paper source after printing.

• If a printer menu operation is in progress

Select the paper source after the menu operation.

• When in the process of loading paper

Finish loading the paper before selecting the paper source.

• When in the process of replacing Ink T anks

Finish replacing the Ink T anks before selecting the paper source.

• If the T op Cover is open

Close the T op Cover before selecting the paper source.

After you select the roll as the paper source, a message is displayed instructing you to load the roll. At this

point, load the roll. ( → P .180)

Note

• If any paper is loaded that will not be used, remove it before loading the roll.

( → P .184)

( → P .214 )

176 Handling Paper

Canon 2162B002 User Manual

Other manuals for Canon 2162B002