Messages regarding paper
Paper loaded askew .
Cause Corrective Action
Follow the steps below to reload the roll.
1. Lift the Release Lever .
2. Open the T op Cover .
3. Align the right edge of the roll paper parallel to the
Paper Alignment Line .
4. Lower the Release Lever .
5. Close the T op Cover .
( → P .180)
Remove the Roll Holder , insert the roll on the Roll
Holder rmly until it reaches the ange, and load the
Roll Holder in the printer again.
( → P .177)
Paper has been loaded askew .
Follow the steps below to reload the sheet.
1. Lift the Release Lever .
2. Open the T op Cover .
3. Align the right edge of the sheet parallel to the
Paper Alignment Line and the trailing edge of the
sheet parallel to the paper alignment line under
the Paper Retainer .
4. Lower the Release Lever .
5. Close the T op Cover .
( → P .210)
Note
• T o disable this message (if it is displayed repeatedly despite reloading paper , for example), choose Off
or Loose in the Skew Check Lv . setting of the printer menu. However , this may cause jams as paper
may be askew when it is printed. Also, the Platen may become soiled, which may soil the back of
the next document when it is printed.
Error Message 767
To Next Page
Loading...
Need help?
General