Messages regarding paper
Paper size not detected.
Cause Corrective Action
Reload paper straight, in the correct position.
( → P .180)
( → P .210)
Paper has been loaded askew , or warped paper has
been loaded.
Remove the Roll Holder , insert the roll on the Roll
Holder rmly until it reaches the ange, and load the
Roll Holder in the printer again.
( → P .177)
Leading edge detection error .
Cause Corrective Action
A roll has been loaded when sheets are selected as
the paper source on the Control Panel .
Either remove the roll and load a sheet or select the
roll as the media source on the Control Panel .
The sheet is loaded askew . Reload the sheet straight, in the correct position.
( → P .210)
End of paper feed.
Cause Corrective Action
Y ou are pressing the ▲ button on the Control Panel
and trying to rewind the roll to the edge.
Release the ▲ button.
Paper can be retracted only up to 17 mm when using
the Media T ake-up Unit .
Release the ▲ button.
Cannot feed paper .
Cause Corrective Action
Reload the paper correctly and advance it again.
( → P .180)
Paper came out of the feed path during feeding.
If the message is displayed when paper is not being
advanced, contact your Canon dealer for assistance.
Paper jam.
Cause Corrective Action
A paper jam occurred in the printer during printing. Lift the Release Lever and remove the jammed paper .
( → P .199)
( → P .215)
768 Error Message
To Next Page
Loading...
Need help?
General