Messages regarding paper
The roll is empty .
Cause Corrective Action
There is no more paper left on the roll. Follow the steps below to replace the used roll with a
new roll of the same type and size.
1. Remove the roll.
( → P .184)
( → P .179)
2. Load the new roll.
( → P .180)
3. If no barcode was printed on the roll, specify the
paper type.
( → P .186)
4. If no barcode was printed on the roll, specify the
paper length.
( → P .187)
Rewinding error .
Cause Corrective Action
There is some foreign object near the Media T ake-up
Unit sensor and the roll cannot be detected.
Remove the foreign object near the sensor .
The Media T ake-up Unit sensor is soiled and the roll
cannot be detected.
Wipe the sensor with a dry cloth to clean it.
The roll is out of range of detection of the Media
T ake-up Unit sensor .
Reload the roll. ( → P .180)
The Media T ake-up Unit sensor is damaged. Contact your Canon dealer for assistance.
* Printing will stop momentarily if an error involving the Media T ake-up Unit occurs. If you prefer printing
not to stop, set Skip T ake-Up Err to On .
T urn on the media take-up unit.
Cause Corrective Action
The Media T ake-up Unit was of f when you selected
Enable for T ake-up Reel .
T urn the Media T ake-up Unit on.
Media take-up unit ready .
Cause Corrective Action
Press the Stop button and stop printing.
The mode switches from take-up mode to regular
mode after you change the T ake-up Reel setting in
the MAIN MENU from Enable to Disable and lift the
Release Lever , or after you execute Paper Cutting .
The T ake-up Reel setting in the printer MAIN MENU
was changed from Enable to Disable , but a print job
was received before the roll was removed.
Press the Online button to resume printing.
770 Error Message
To Next Page
Loading...
Need help?
General