117
Customizing System Operation (System Settings)
Operation Setting Functions from Menus
Setting a Password
> [System settings] > [Other settings] >
[Register password]
You can register a password for
starting projection.
Press the OK button after selecting
[Register password], and the following
screen for registering a password
appears.
Enter a 4 digit password.
Enter the password using the [ ] / [ ] /
[ ] / [ ] buttons.
The 4-digit password is entered from
the left to right digits. When the final
digit is entered, the password is
automatically registered.
Press the MENU button to abort the
registration.
To Cancel the Password
Turn off the projector and unplug the
power plug.
Hold down the MENU button on the side
control and connect the power plug.
Make sure to keep holding down the
MENU button until a beep sounds. When
the beep sounds, the password is
canceled. (The entered password is also
reset.)
To forcibly cancel the password from the
remote control, in standby state press the
MENU button 3 times, then press the
POWER button.
HDMI Component LAN
Digital PC Analog PC USB
To Next Page
Loading...
Need help?
General
