Step 2 Select an Input Signal
54
Selecting an Input Signal
1 Press the INPUT button to display the window shown below.
The currently active input signal is marked with a green circle and enclosed by
a orange border.
An input signal that is ready for projection is displayed in white. When no signal
is received, it is displayed in gray. However, [Digital PC] or [Analog PC-1] may
be displayed in gray even if these signals are ready for projection.
2 You can switch the available input signal types by pressing the INPUT
button.
• You can select the target input signal with [ ] / [ ].
3 Press the OK button to confirm the input signal type.
• Screens of computers connected to the projector over a network can be projected
when you have selected [LAN] as the input signal. For details, refer to Networked Multi-
Projection (NMPJ).
• Images on USB flash drives can be projected when you have selected [USB] as the
input signal. For details, refer to “Projecting Images on a USB Flash Drive” (P79).
• In split-screen mode, the side without control rights is identified by a white circle.
Remote control Projector
To Next Page
Loading...
Need help?
General
