Using Layout Functions
266
■ Switching the Primary/Secondary Monitor
Using the application, you can switch between projection from the primary or
secondary monitor.
If your computer has dual monitor support, the computer icons are labeled with
numbers. The primary monitor is labeled “1,” and the secondary one, “2.”
To switch the monitor used for projection, click the icon of computers shown with a
number.
■ Temporarily Enlarge Images
During display from multiple computers, you can enlarge projection from one of the
computers. To enlarge the display, place the cursor over the computer in the layout
area, click in the upper left, and then click [Start projecting]. The image from
the selected computer is now projected in full-screen mode.
To cancel the enlarged display, place the cursor over the computer in the layout
area again. Click in the upper left, and then click [Start projecting].
To Next Page
Loading...
Need help?
General
