Installation-Related Menu Settings
155
Installation and Maintenance Installation
Showing/Hiding Input
Status
> [Install settings] > [On screen] >
[Show input status]
You can select whether the signal
status is displayed on the screen
when there is no signal or when
making signal settings.
Press the OK button to accept your
setting and then press the MENU
button or EXIT button.
• The factory default is [On].
Showing/Hiding
Overheat Warnings
> [Install settings] > [On screen] >
[Overheat warning display]
You can select whether or not to
display the [High temperature
warning] icon when the temperature
inside the projector has increased
and is approaching the overheat
temperature.
Press the OK button to accept your
setting and then press the MENU
button or EXIT button.
When [On] is set, the [High temperature
warning] icon shown below will be
displayed when the temperature inside
the projector is abnormally high.
• [Off] is the factory default.
HDMI Component LAN
Digital PC Analog PC USB
Off The input status is not displayed.
On The input status is displayed.
HDMI Component LAN
Digital PC Analog PC USB
Off The [High temperature warning] icon is
not displayed.
On The [High temperature warning] icon is
displayed.
Screen
To Next Page
Loading...
Need help?
General
