84
Using Menus
Use the menus to set the operation of the projector in detail.
Menu Configuration
The menu screen is divided into 6 tabs as shown below.
Menu items
[System settings] tab
You can set the operation of the
projector.
[Network settings] tab
These settings are for when using
the projector from a PC via a
network.
For the network settings, refer to
“Connecting to a Network” (P167).
[Information] tab
You can check information
about the signal types of the
images projected and other
information.
Contents of menu
[Input settings] tab
You can set the type of signal
or the method of projection of
the images input.
[Image adjustment] tab
You can adjust the image quality
and colors according to your
preference.
[Install settings] tab
This setting is used when installing
the projector.
Input Signal Types for which a Menu Item is Displayed
Different menu items are displayed for different input signal types.
In the following explanation of each menu item, the input signal type for which
the menu item is displayed is indicated as follows:
HDMI Component LAN
Digital PC Analog PC USB
Input signal for which the
menu item is displayed
Input signal for which the
menu item is not displayed
To Next Page
Loading...
Need help?
General
