Canon WUX450 User Manual

Installation-Related Menu Settings
156
Specifying the Menu
Display Time
> [Install settings] > [On screen] >
[Menu display time]
The setting for the menu display
time can be extended from the
normal 10 or 30 seconds to 3
minutes.
Press the OK button to accept your
setting and then press the MENU
button or EXIT button.
• [Normal] is the factory default.
• The following display and operation are also
changed.
Showing/Hiding Lamp
Replacement
Warnings
> [Install settings] > [On screen] >
[Lamp warning display]
A message that advises you to
change the lamp can be set to
display when the lamp has been
used for the specified period of time.
Press the OK button to accept your
setting and then press the MENU
button or EXIT button.
• The factory default is [On].
HDMI Component LAN
Digital PC Analog PC USB
Normal The menu is displayed for 10
or 30 seconds.
Extended The menu is displayed for 3
minutes.
Item [Normal]
[Extended]
The display time of the
following screens
-MENU screen
30
seconds
3
minutes
-Input (P54)
-Keystone adjustment
(P68)
-Keystone reset (P70)
-D.image shift
adjustment (P63, P64)
-D.image shift reset
(P65)
-Aspect (P67)
-Image Mode (P71)
-Volume adjustment
(P77)
-Gamma correction
(P100)
10
seconds
3
minutes
HDMI Component LAN
Digital PC Analog PC USB
On The prepare lamp message and the
lamp warning are displayed.
Off The prepare lamp message and the
lamp warning are not displayed.
When it is time to replace the lamp,
the LAMP indicator on the projector
will flash, and lamp replacement
(P202) is recommended at this time.

Canon WUX450 Specifications

General

Brand	Canon
Model	WUX450
Category	Projector
Language	English