Installation Procedure
131
Installation and Maintenance Installation
â– Projection from High Surfaces
For projection from a shelf or other high surface, the projector can be installed
upside-down and the projected image inverted. In this case, attach the option feet
on top of the projector.
Attaching Option Feet (RS-FT01, Sold Separately)
Remove the hole caps and screw the option feet into the holes.
The caps are located at four positions on top of the projector. They are removed
differently depending on their position.
Removing hole caps labeled (1)
Pry off the caps by inserting a slender tool such as a flat
screwdriver in the depression.
When setting the projector on a
high surface for projection, be sure
the surface is flat and stable.
Failure to do so could result in the
projector falling down and causing
an accident or personal injury.
Top
(2)
(1)
(1)
(2)
To Next Page
Loading...
Need help?
General
