Cisco ASR 920 series Configuration Guide Ethernet Router

PurposeCommand or Action
Enables SNMP trap generation for Ethernet CFM mep-up,
mep-down, config, loop, and cross-connect events.
snmp-server enable traps ethernet cfm cc [mep-up]
[mep-down] [config] [loop] [cross-connect]
Example:
Device(config)# snmp-server enable traps ethernet
cfm cc mep-up mep-down config loop cross-connect
Step 21
Enables SNMP trap generation for Ethernet CFM
mep-unknown, mep-missing, and service-up continuity
snmp-server enable traps ethernet cfm crosscheck
[mep-unknown | mep-missing | service-up]
Step 22
check events in relation to the cross-check operation
Example:
Device(config)# snmp-server enable traps ethernet
cfm crosscheck mep-unknown mep-missing
service-up
between statically configured MEPs and those learned
via CCMs.
Returns to privileged EXEC mode.end
Example:
Device(config)# end
Step 23
Provisioning the Network on the PE-AGG B
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ethernet cfm domain domain-name level level-id
4.
service short-ma-name evc evc-name vlan vlanid direction down
5.
continuity-check
6.
continuity-check [interval cc-interval]
7.
exit
8.
mep archive-hold-time minutes
9.
exit
10.
ethernet cfm global
11.
interface type number
12.
service instance id ethernet [evc-name]
13.
encapsulation encapsulation-type
14.
bridge-domain bridge-id
15.
cfm mip level level
16.
end
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
156
Configuring Ethernet Connectivity Fault Management in a Service Provider Network
Configuring Ethernet CFM

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English