Cisco ASR 920 series Configuration Guide Ethernet Router

PurposeCommand or Action
Displays the port channel configuration.
show running-config interface port-channel group-number
Example:
Device# show running-config interface port-channel
10
Step 7
show etherchannel summary
Step 8
Example:
Device(config)# show etherchannel summary
For the LACP 1:1 redundancy feature, both ends of the EtherChannel must be enabled.Note
Example
This example shows how to configure an LACP EtherChannel with 1:1 redundancy. Because Fast Ethernet
port 5/6 is configured with a higher port priority number (and therefore a lower priority) than the default of
32768, it will be the standby port.
Device> enable
Device# configure terminal
Device(config)# lacp system-priority 33000
Device(config)# interface range fastethernet 5/6 -7
Device(config-if)# channel-group 1 mode active
Device(config)# interface fastethernet 5/6
Device(config-if)# lacp port-priority 33000
Device(config)# interface port-channel 1
Device(config-if)# lacp fast-switchover
Device(config-if)# lacp max-bundle 1
Device(config-if)# end
Setting LACP System Priority and Port Priority
Perform this task to set the LACP system priority and port priority. The system ID is the combination of the
LACP system priority and the MAC address of a device. The port identifier is the combination of the port
priority and port number.
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
364
Configuring IEEE 802.3ad Link Bundling
Setting LACP System Priority and Port Priority

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English